2020 Extrusion PTFE & ECAS 180 Degree Swivel Arm - Voron 2.4

Pick from the UCAS Support or the Standard M3 coupling (small hole version)

Prints in place no required supports, i have build them into the models which are easy to remove. (3 small pins which is where the screws go in)

Required Hardware. V1

2x M3 12mm Screws

2x M3 Hammer Nuts

V2 has a extra screw on the top of the mount so to prevent wobble on the arm.

Required Hardware. V2

3x M3 12mm Screws

2x M3 Hammer Nuts