Slide-on Headphone Hanger

I based the dimensions of this hanger off the IKEA IDÅSEN desktop.  The hanger will fit on desktops with a thickness less than 29mm.  If the hanger is too loose for your desktop, a piece or two of high-friction material will hold it in place.

Printer settings

When I printed this model, I used the following settings:

• Nozzle: 0.4 mm
• Layer height: 0.2 mm
• Wall Thickness: 0.8 mm (2 lines)
• Infill: 60% Cubic
• Supports: None 

I plan to later release a version where the desk thickness can be adjusted on the hanger.

HeadphoneHanger © 2024 by Anderson Dauer is licensed under Attribution-NonCommercial 4.0 International