This was designed for a Hover-1 Titan, but I suspect that it will fit most charging ports.
Printed on Ender 3 V2 with Direct Drive extruder and Micro Swiss hotend
Material: PolyMaker TPU95 (You need a squishy material for this to work)
Layer height: 0.2
Speed: 15 for everything (It prints in under 9 minutes)
No supports
Infill: 15% Grid
Top shell layers: 2
Bottom shell layers: 2
The open ring simply slips down over the thread of the port connector. The cap should fit snuggly around the connector leaving a small loop of the strap exposed. This makes it easy to remove the cap for charging.
The author marked this model as their own original creation.
