ratgdo 2.5i Enclosure with Wago 221 Lever-Nuts & M3 Self Tapping Support

This is a remix of the original ratgdo PCB Case from @samwiseg0 along with the awesome remix from @PatrickONeal_471773 that added support for Wago connectors to improve wiring support – Wago connectors will change your life!

The original Wago integrated version noted that it was only for the case that used screw inserts (melting) and did not contain a version to support self-tapping M3 screws which is provided by the original PCB case version.

Notes:

• Printed, Composited, & Exported with Cura v5.4.0
• The Wago holders are a very tight fit and takes some force to insert, but once they are installed all clips open without any issues.

Print Settings (Same as Original PCB Version):

• 4 Perimeters/walls
• 5 top and bottom layers
• 25% Gyrioid Infill
• 0.4mm line width
• Parts are pre oriented in the correct position for printing
• No supports!

This is a merging remix of the original ratgdo PCB Case from @samwiseg0 along with the awesome remix from @PatrickONeal_471773 that added support for Wago connectors to improve wiring support – Wago connectors will change your life!

This remix merges these two to now provide a version for self-tapping M3 screws instead of only for screw inserts.