Plug Charger Power Adapter Holder Organizer

Two versions are available. V1.1 will have a fixed screw mount on one end and an adjustable mount on the other. The V1.2 version not only allows for the most versatile mounting but also accepts three prong plugs! Which might be helpful with extension cords all that stock pile of monitor cords. 

V1.1 can be printed face down, if you want the plates' texture visible, without support though for V1.2 you may want some support to bridge the gap.

I used an M4x16 screw and M4 hex wall adapter to mount to my hex wall. Can also just be wall mounted with standard drywall screw into a stud or however you see fit.

For both versions the plug slots may still require a few plugging and unplugging's to loosen the holes up. If a plug feels tight on first insertion, do not just ram it in! Work it up and down and in and out a few times and should eventually just slide right in with little effort.

Any suggestions or remixes are welcome! Happy Printing!

If so inclined to fuel my productive addictions all contributions are greatly appreciated here.