iPAD (Air) Adjustable Stand

The holding arms are much tighter, 20mm longer than the original, and designed to hold a 2022 iPad Air. The arms have a 0.5x8mm cutout where you can glue a 1-2mm thick foam (rubber) strip for a soft grip on the iPad. (I used 2x8mm rubber).

Adds additional adjustment to stand. Goes lower another 20 degrees, while still supporting all the original adjustment points. This makes it a bit better for drawing while at a table. The arms can be used with the original hooks that hold tablet. These back arms also accept the original back support.

There is one STL file that contains 2 of the hook pieces and 2 of the back arms. 

I printed @0.2mm layer and 3-4 perimeters using PLA. 

Some had problems attaching the back support to the back arms. Simply get a small file (l used a large metal nail file) that has teeth on the edge and file the inset of the tabs a bit. This makes the back support go easily, but with enough friction so it won't release on its own.

1. Adds another lower (20 degree) adjustment
2. 20mm longer arms to hold tablet (arms are much tighter and designed for 2022 iPad Air without case
3. 0.5mm inset for foam lining