Scuba tank grip

Suitable for this tank!

The most ideal is to print it with perimeters only (set 999 in PrusaSlicer), but you might want to save some material. For this reason, we suggest using at least 8 perimeters and increasing the infill to 70-80%. The grip works just fine printed with PETG and TPEE insert (Filatech FilaFlex40). Just don’t forget to tighten the screws properly and test the grip with a mattress under the tank before using it regularly.

Hardware needed:
M5x50 screw - 2pcs
M5 washer - 2pcs
M5 nut - 2pcs