LED Remote Holder Magnetic Back

I designed this back to fit on the mount for the BTF-Lighting RC01RFB RF Dimming remote and uses 5mm x 2mm magnets. I had a few lying around and I wasn't sure how many were going to be needed to hold the remote onto my workbench so I filled the back with plenty of places to add the magnets. I used a dab of Gorilla Super Gel for each magnet and placed them in the holes. I then used the Gorilla Super Gel to glue it to the back of the provided mount. I took a snip of the mount shown without the back from the Amazon listing linked above for reference. It is printed from Printbed Black PLA using the generic PLA settings on my X1C. If you don't want to use so many magnets, you can add a few and test if it holds. If it doesn't, add some more magnets and retest. Repeat this process until you have enough magnets installed to hold the remote.