Remix Laptop stand with connecting rods

 Just a couple simple connector rods, was going to glue them in but they were snug enough of a fit I didn't bother.  tried to make them blend in with the regular model and not botch it up too much.  Hope it saved you a few minutes. 

Version 2 includes minor changes to solve the issue of connector rods not fitting if using a different infill percentage. Print without bottom and top layer and Hex infill if you wish to have the same open look. 

Only changes from original was to add a couple connecting rods.  The file i added to was https://www.printables.com/model/255402-update-vertical-laptop-stand-take-3/comments/1408899