Spengler wand rear grip

This is a complete replacement for the ghostbusters Spengler wand rear grip.

Simply cut off the rubber ‘tape’ on the original handle and unscrew the remaining grip (3 screws in the top, 2 on the side.  This piece replaces the top piece entirely and uses the existing screw locations, though the 2 side screws need to be replaced with longer versions.  Honestly, I'm not sure the side screws are necessary but I'm using them.

This should look great sanded and painted.

Print with 3 perimeters and .2mm height.  Designed for FDM printing, standing up, with round edge of teardrop shaped screw holes facing closer to the bed.

Who's afraid of no ghost?