Lack Enclosure Wall Brace

Brace for your lack enclosure that allows for variable depth. I designed it to use a mounting tape on the wall-side, feel free to remix it to allow it to be screwed into the wall. Use a total of 4 - one on each side of each tabletop right above where the legs screw in.

These braces, especially when combined with my other model, makes for a super solid printer with very little vibration. I was able to achieve over 10k acceleration on the X-axis of my modified Ender-3 with this combination!

Printed in PETG, with the brace on its side. I used supports, but with well-tuned bridge settings you can probably get by without them.