Fingerboard Skatepark Modular - Ramps, Rail and Stairs

Jump and grind how you want and where you want. At any time.

It is modular, so you can start small and go big over time!

Update 2024-01-21: 3rd addon uploaded! Thanks for the first makes :-) Transition from low to high block, small ramp and some blocks.

Update 2024-01-11: 2nd addon uploaded. Small stairs with and w/o rail, small and medium block w/ and w/o rail with half height and updated connectors.

Update 2024-01-01: 1st addon uploaded. Kicker and small base. Thank you for the likes and downloads!

Print Instructions

Print the parts you need and the connectors.
Thera are small, medium and big connectors for the different heights of the modules.
All models are in recommended print orientation.

I added a test file. Use this models to check if the tolerances fit your needs.
Scaling the models could help if it does not fit. Or some sanding or a drop of glue…

Filament type: PLA or similar
Layer height: 0.2mm (You can also use variable layer height in PrusaSlicer)
Walls: 3 or 4
Top/Bottom Layer: 5 or 6
Infill: 10% or 20%
Support: no

For some models there are hollow versions. You can choose what you like more.

Assembly Instructions

Connect two of the parts with one or two connectors, depending on the models.

Addons / Options

If the model gets likes and downloads I will add more modules.
You can post ideas in the comments, I will try to realize them.