Note 10 5G minimal hex case

My mom loves this phone, she dislikes the store bought masks cause they're too clunky.
The case seen on the images is printed on an Ender 3 v2, with Verbatim Green ABS.

Print suggestions:

1. Suggested Material: ABS, PLA or PETG,
    
2. Nozzle: 0.4mm
    
3. Parameters/infill: at least 4 params, with at least 20%. You could go higher or print 100% infill for a more sturdy print
    
4. Layer height: 0.2mm works fine
    
5. Supports: The “Organic” mode, auto-generated ones from PrusaSlicer work just fine.