Cable Clip

A small, low profile cable clip with seven slots that snaps closed to ensure you cables don't get crossed. To open; grab the face in roughly the middle and pull, if that doesn't work insert a fingernail or thin object into the slot and bend out slightly then pull with your other hand. I have been able to get these open just by pulling on the middle but if your printer has an issue with z wobble or printing in tight tolerances I recommend scaling the print up to 110-115% to ensure the clip will work.

I recommend using whatever PLA settings work for your printer with NO SUPPORTS. Just make sure you turn off brim/raft unless you really need them as getting the brim out of the print is tedious and hard to clean up. I also recommend printing slightly slower than usual given the tight tolerances and and micro overhangs.

Let me know what you think about this design and what I can improve on:)