Nespresso Vertuoline Pod Capsule Dispenser / Holder for new Packaging

Nespresso changed their packaging on the virtuoline capsules without warning and made the old capsule holders worthless (the ones that hold the cardboard inserts) so I offer this version that works like the Classicline holders that you see here all the time.

Just open the box and tear off the flap and fit it into the top hole. When you turn it back over the capsules will cascade down into the tray in front. It works well.

No scaling should be necessary if your printer works reasonably well. The fit should be clean but have plenty of tolerance.

.2mm layer height is just fine and you can print at smaller layer heights if you want the ramp inside to be oh so smooth.

Edit 5/9/19: Added models for 2up, 3up, 4up, and 5up versions. Now you can have LOTS of dispensing going on.

Edit 6/12/19: Small modification to the design to better keep box from sliding too low in dispenser.