Sig Sauer P238 Speedloader

The only change I made to the original model was to add inset or offset labeling to the back of the speed loader.

• Supports: Yes, I used tree supports because there is an internal structure that needs it to print nicely.
• Infill: At least 10%. Anything above 25% doesnt really add much structural rigidity.
• Printer: Crealty Ender 3 S1
• Filament: eSun PLA+
• Print Temp: 210
• Quality: 0.28
• Slicer: Cura
• Adhesion: You can use a Brim if you want. I did but it should print fine without one. 

The only change made by this remix is I added a label on the speed loader to indicate which firearm it fits. I made two versions, an inset and an offset version. Just pick whichever one you like. I recommend at least 10% infill and supports.