BetaFPV Pavo Pico frame duct

Changelog:

• 2024.01.27: Add file pavo_pico_duct_with_feet_flanged.stl:
  • Height is +1mm to a total of 6mm
  • Flange the base to +1.5mm all around for added strength and overall stiffness

Lightweight replacement frame duct for the BetaFPV Pavo Pico. It's a bit slimmer than the stock one and weight less. There's also an additional version with mountpoint for landing gears as the battery is mounted below (weight similar to stock in this case).

• No additional hardware required
• No support, print as it
• Designed for 0.4mm nozzle (0.9mm wall thickness)
• 2 perimeters, 0% infill
• Print size 106x106x7mm
• Feet are 25mm height

Print whatever version suit your need. In case of the version with landing gears, you can glue them or use M2 screws. Threat the hole as self tapping, don't force them. Adding brass insert would only increase weight when we don't disassemble it much in theory.

The duct is 5mm in height which is the exact size of a COB led strip (that cannot be attached to the stock duct since it's curved).

I didn't believe paying 2.07euros on Cults for that was worth it so here is my free version with added benefits.

---

• Stock: 8.5gr
• Naked: 5.25gr
• With landing gears, duct only: 5.8gr
• With landing gears, duct and 4x gear: 7.7gr
• With landing gears, duct, 4x gear and 4x M2x4: 8.5gr