Legs for the Prusa Enclosure

I like this setup a lot. It gets this giant thing off the side of my desk and transforms it into a useful piece of furniture. Nicely done on these legs. I should have printed them a long time ago.

Works great and looks great, the extra height allowed me to add some storage drawers underneath the enclosure. I definitely think this is a 5/5 for quality and usefullness

It would be helpful to tell us how much this raises the enclosure after installation.

These came in handy for how I'm using my enclosures. Just like your image, my printers are furniture and these are perfect. Thank you!

Printed in PETG Galaxy Black on an MK4S (6h per leg). Gyroid infill 20% and 50% in the screw area. Feels very solid and looks very nice. The design fits the enclosure very well. Used the spare screws & nuts which came with the printer & enclosure.

Creates a great height for access while sitting at the desk.

Printed in Overture black PETG as part of my printer and enclosure upgrade to the MK4. Now it fits much better next to my computer desk.

Looks super nice compared to setting the printer on the ground.

I used PETG in Galaxy Black.

Like the author, I was going to put my printer on the ground and these seem like a good idea. I went with 4 outer walls and heat set inserts.
I do not own a cat, and no I don't want one, so I have no idea if it is cat friendly.
Thank you these worked out great.

The right amount of lift can fit a robot vacuum under it.