USB cable clip

Cheapest cable clip for USB cables.

For 4-5 turns.

Material: PETG

Nozzle size: 0.2, 0.3 or 0.4 mm

Layer size: 0.05 or 0.1 mm

Should be infilled 100% with concentric patter and concentric top and bottom. For this increase wall lines count setting in your slicer. Values from 7 is enough for any nozzle bigger than 0.2.

Do not rely traditional infill or top/bottom concentric patters.

If you print with non concentric structure you may damage your cable.

Do not scale. It is very tight. By scaling down you may damage your cable.