Voxelab Aquila/Ender3V2 S1 LED Converter

This is the remix of great CR6 2020 extrusion end cap by mourix!

With this end cap base converter, you can mount well installed Ender3 S1 LED lighting module on your Voxelab Aquila/Ender3V2 or any close or same X extrusion printers.

• Top side is 8mm gap and bottom side is 7mm gap so it is not reversable for better fit.
• You can use heat bolt melt way or thread tapping to make the bolt tap with existing hole.
• It perfectory fit on my Voxelab Aquila S2, regardling power supply you can just directly use 24V supply with original terminal removing from connector so any converter or special customization will NOT be required.

Print Settings

Printer:

Voxelab Aquila S2

Rafts:

Supports:

No

Infill:

Filament: N/A PLA