Mesh covers for Iceriver KS0 Pro, KS0 Ultra, AL0 and RX0 miners

These are two mesh covers to replace the original side panels of the Iceriver KS0 Pro, KS0 Ultra, AL0 and RX0 miners.

The original side panels are completely closed and the cooling relies on the two small intake fans at the bottom of the case. Warm air only has a few holes on the top of the case to exhaust.

With these mesh covers more warm air can escape the case and airflow is increased. Therefore my temperatures have decreased by 2 - 3°C. I also use an 120mm exhaust fan on top of the miner but it has been running before and after the use of the mesh covers.

Notice that the KS0 and the KS0 Pro/Ultra have different side panel layouts. The models shown here won't fit the original KS0!

As the miner can reach temperatures up to 60°C, I would not recommend using PLA or PETG for the print. In my case, I used eSUN ABS+ that withstands temperatures up to 73°C (manufacturer's specs).

Printed with:

• eSUN ABS+ Black
• @270°C
• 0.2mm layer hight
• 0.4mm nozzle
• on Bambu Lab P1P (+ enclosure)