Ender 6 mods - Linear rails + Voron TAP mounts

A collection of things i made for myself when i couldn't find something pre-made that suited my needs. Most of this could probably use some tweaking still, i've included .step files to make that a little easier. currently working with my setup with excellent results.

Linear conversion is all MGN9 rails. Z rails will need 2x sliders. Hotend may benefit from using MGN12 instead of MGN9, but i'd already bought MGN9 so thats what i've used.

TAP conversion uses original belts and is working fine, but belt clamps could use some work (if i get around to it, i'll make them clamp the belts before bolting to the backplate). you'll need to grab the original Voron files and print the 2 i've modified to get it working. 

Pi/board mount is for an SKR3 EZ board and a Pi3. other Pi units should fit just fine, you'll have to work out if other boards will work (or add other mount points)

cable chain mounts are made for a huge 40mm cable chain

temp guage is a cheap little ebay voltage/temp guage that gives me a readout of the lower and upper sections of the chamber, i added a front switch to this so its easier to turn the machine off in my setup.

Edit!

Added some more bits and bobs.

XY linear rail mounts changed to lower the hotend and incorporate the rollers into the mounts. this is a fair bit more of an operation to install than the previous model, but adds some rigidity and lowers the hotend a little (i wanted this so it would fit better in the space i use it in)

Voron TAP mount changed to utilize an MGN12 rail. previourly using an MGN9 because i ordered the wrong thing, the 12 is a much better fit for the purpose. also adjusted the belt mounts a little so they clamp better.

Reversed the spool holder so it is internal, helps keep the filament warmer and drier but also easier to load if the printer is in a tight spot.