The 100 printer - Enclosed Power Socket - low rear mount

Hi, have been working on a discrete power socket mount for the 100 v1.1.
It has a fully enclosure in the rear and has a port to allow wires to run to the power supply.

It is a 2 part construction that replaces the connector bar in the rear of the printer and becomes a structural componant of the printer.

this is the switched plug socket I ordered 

https://www.aliexpress.com/item/1005003128381031.html?spm=a2g0o.order_list.order_list_main.28.2c7e1802A8AWi4&gatewayAdapt=glo2deu

As a side note, this works best with the BOM power supply which requires an additional print to attatch the power supply to the 100's frame

https://www.printables.com/model/600391-psu-mount-for-the-100/comments/1397364

it also works with the full electronics case

https://www.printables.com/model/696207-electronics-cover-for-the-100/comments/1457334

I hope you find this useful.

this is a new element that replaces the rear connector for the frame to include a switching power socket for extra safety. the design is a 2 piece model that fully encloses the switched plug socket.