Quest 3 All-in-One Stand

I wanted to print an all-in-one stand for the Quest 3 but most were either headset or controller stand options. This is a combination of my two favorite options available online.

I printed this on the Bambu P1S. The footprint of the model is slightly larger than the 256x256mm bed so I had to orient it vertically to print. I printed the model in the pictures above with the following settings:

• Nozzle: 0.4mm
• Layer Height: 0.24mm
• Infill Percentage: 5%
• Infill Pattern: Gyroid

Combined them in Fusion 360 by sketching a connecting path between the controller holders and the precision stand piece. Both great options by themselves - so I made them one.