Honeycomb Wall Holder for Brennenstuhl PL 200 flashlight

Description

This is a holder keeping your Brennenstuhl PL 200 flashlight nicely on your Honeycomb Storage Wall (HSW) for easy retrieval. The model was designed for the PL 200 AC model, but should fit the other model variants as well.

What is needed?

• print model either from the provided step or stl
• no additional inserts needed

How to print

Use support for insert attached to the holder model. Or print without support and make manual corrections (e.g. by pulling off some unclean parts with pliers or by sanding a little - for me, this was perfectly fine). 

I suggest to stick with the original suggestions for printing holders and inserts for the honeycomb wall: Use any material you like (I used red PETG), with layer height of 0.2mm, 4 perimeters and 20% infill. 

Used the original empty insert and designed the holder attached to the insert myself.