Temperature and Humidity Display Mount for HSW - Better insert plug

Temperature and humidity display mount for the honeycomb storage wall system.

Fits for example https://www.amazon.de/dp/B07XD7VRFQ?psc=1&ref=ppx_yo2ov_dt_b_product_details sensors from “Thlevel”

Note that the spool holder in the photos has a HSW compatible grid.

The original was a bit too high for my sensor and the HSW plug too small / loose, so that the mount fell out very quickly from the grid.

• Replaced the HSW insert plug with another, this one is very tight. Might require some sanding / filing where the support is attached to fit properly
• Reduced the height by 1mm, from 35 to 34mm, to better fit my sensor. 

I am including the original height (35mm) as well as my reduced version (34mm) and my 3mf project file to allow easy changes.

Printed with “organic” support, which is also setup in the project file.