LM8UU Bearing

Other LM8UU bearings are modeled without much thought put into how the part will be printed.

I modeled each of these to be printed with a their corresponding nozzle size using no infill, no top and bottom layers, and a wall line count of 1.

I would suggest using a persist z-seam for consistancy.

Because of the precise dimensions, this piece will print very quickly. I print the .04mm nozzle size in 13 minutes at .24mm layer height and 25mm/s (only outer wall speed matters here).

If you have a .2mm or .3mm nozzle, use the file meant for the .6mm nozzle. The wall thickness for those would be too delicate.