LTT Stubby Screwdriver + Bitholder for 24 bits (now Gridfinity compatible)

As I searched around and could not find something already existing which fits my needs, I created that holder for the LTT Stubby Screwdriver – Linus Tech Tips Store (lttstore.com) and some additional bits, because I was also tired of having the parts laying around loosely.

The screwdriver is either a loose or a snug fit (depending on the orientation of the orange end-cap) and I also added some space for (optional) 6x2mm round magnets to keep the bits in place. These can also be left out. 
If you choose to add them to the build, just pause the print to add them. I also would recommend to add a drop of super glue to keep them in place during the print-process.
If you do choose to not add them, just leave the holes as they are. They should be closed properly even without magnets and will not be seen after the print.

I also created both parts separately, so you can print only the screwdriver holder or the bit-holder not connected to each other.

There is also one option with the LTT-logo (add an additional print pause to swap the filament for a colored accent) and one without.

I printed mine in black and orange (like the “original” LTT-colors) and it came out very nice.

Design has been made with 0.2mm layer height in mind (especially for the magnet inserts).

It also fits nicely on an Ender 2 Pro (165x165mm print bed), which I currently use most for everyday printing.

UPDATE 2024-01-02: added a 2x3 Gridfinity-roster upon request! Hope it fits (did not try.. Please verify in the comments!)