P1P/P1S 8mmLED Light strip bracket

Because the P1P/P1S original LED light is too weak, I want to improve the brightness of the light, but I don't want to destroy the state of the original light, so I made a bracket and installed it on the bracket with an 8MM LED white light strip, and the card slot will not fall off due to high temperature. Use the GH1.25 terminal, cut the LED strip into 28mm (I used 28mm 17 lamp beads) for simple soldering, print the bracket above, put the strip light into the card slot, unplug the original LED lamp holder, insert the soldered GH1.25 terminal, and install it in the chassis with M3X10 screws (position as shown in the picture), you can. This method is simple and non-destructive, and you can continue to control the lights with the printer. Please don't consider adding too many lamp beads. Check out the official documentation This socket can only withstand 0.3A, so only one strip light is installed. so as not to cause damage to the sieve plate.