Improved Rotor for the Creality UW-02 Wash and Cure

Improve the washing power of the Creality wash & cure UW-02 by 200%. This model is an improved rotor for the Creality UW-02 Wash & Cure station.

With bigger paddles it creates a nice vortex in the tank. The washing power of your mashine is highly increased using this custom rotor. Now your Creality Wash & Cure UW-02 is as powerful as other brands like the Anycubic Wash & Cure.

You need the following parts from the original rotor of the Creality UW-02 wash & cure station: 2x magnets 20mm x 5mm 1x ball bearing 16mm x 5mm

To secure the magnets and the ball bearing you need an additional 4 screws: 2x 10mm flathead plastic screw 2.2mm diameter 2x 5mm flathead plastic screw 2.2mm diameter

Recommended print settings: PETG, ABS or PLA, make sure the filament is not reacting to your washing fluid (use recommended filament settings) 0.2mm layer height enabled supports no adheasion

If the tolerances of the bearing and magnet holes do not fit with your print settings, scale the model in the slicer by +/- 1%.