BevelledSquare Puzzle

The  Puzzle

The puzzle consists of 10 puzzle pieces and a slider box.

There are 159 solutions. It is not easy to solve.

The puzzle pieces are used on both sides.

3D Printing Tips

The size of the sliding top is crucial. If it's too narrow, the bumps on the top won't snap into place. If it's too wide, the top can usually still be inserted, but it becomes difficult to open.
If the lid is slightly too large, you can start by sanding down the bumps slightly. If the top doesn't fit, it is advisable to adjust its dimensions in the slicer and reprint it. Recommended adjustments are only small increments ranging between approximately 0.2mm and 0.3mm in width (only in width).

Here is a short video explaining this

I printed the puzzle with the following settings:

• Material: PLA
• Resolution: 0.2mm
• Infill: 20%
• no supports
• no raft, no brim

Further information about the BevelledSquare Polyforms

The BevellesSquare grid consists of squares and hexagons.

Other

More information about puzzles whose pieces consist of simple geometric shapes (polyforms) can be found at

pentoma.de (german)

If you like check out my other designs too!