Animal Coasters - HueForge

It can be a little tricky to fit them in the coaster. You should also add a tiny drop of glue to keep them from sliding around once they're in.

OWL:
 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black
PLA+ Sunlu Red 
PLA+ Sunlu Copper 
PLA PolyTerra Sunrise Orange 
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Red
At layer #12 (1.04mm) swap to Copper
At layer #18 (1.52mm) swap to Sunrise Orange
At layer #21 (1.76mm) swap to White for the rest.
 

FOX:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black
PLA PolyTerra Sunrise Orange
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Sunrise Orange
At layer #8 (0.72mm) swap to White for the rest.
 

SHARK:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black 
PLA+ Sunlu Blue 
PLA+ Sunlu Grass Green 
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Blue
At layer #7 (0.64mm) swap to Grass Green
At layer #10 (0.88mm) swap to White for the rest.

DRAGON:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black 
PLA+ Sunlu Red 
PLA+ Sunlu Pure Yellow 
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Red
At layer #11 (0.96mm) swap to Pure Yellow
At layer #15 (1.28mm) swap to White for the rest.

BEE:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black 
PLA+ Sunlu Red 
PLA+ Sunlu Pure Yellow 
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Red
At layer #8 (0.72mm) swap to Pure Yellow
At layer #14 (1.2mm) swap to White for the rest.

HUMMING BIRD:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ Sunlu Black
PLA+ Sunlu Blue 
PLA+ Sunlu Grass Green
PLA+ Sunlu Pure Yellow 
PLA+ Sunlu White 

Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Blue
At layer #6 (0.56mm) swap to Grass Green
At layer #9 (0.8mm) swap to Pure Yellow
At layer #15 (1.28mm) swap to White for the rest.