Samsung Galaxy Watch 5, 5 Pro charging stand3d printed to hold charging puck.
Just insert the puck into the location. Run the cable along the tracks. The puck will be a snug fit depending on your print settings. You may have to adjust the model or carry out post-adjustments to print. I am happy to amend if you contact me.
This model was printed with Creality Hyper Pla at 220 Nozzle temp, 60 bed temp and .2 layer height. The model was printed on the side with support. The Cable run was full of support and did take a bit of time to remove. Increase wall thickness until there is zero infill on the left thin section of the stand. This will give more strength there.
LOOKING FOR STAND THAT FITS THE SAMSUNG GALAXY WATCH 6? FOLLOW THIS LINK https://www.printables.com/model/738787-new-samsung-galaxy-watch-6-charging-stand
The author marked this model as their own original creation.