Uk plug saver!

A remix of Dinidu's Tpye G plug model. 
Slide it over the 2 remaining plug prongs and glue it in place if needed.

Print settings (i used, prob not the best):

Infill: 50% Gyroid (make the prong strong 💪)
Supports: no

layer hight: 0.12mm (probably be fine with bigger)
speed: 50mm/s (not sure if you need to know this


Takes around 12 minutes to print with my settings :) (1gram)

So all i did was remove the bottom 2 prongs and slim it out a bit so it would fit on the original plug. 

Thanks to Dinidu for their Type G plug model, you did all the work!