birdhouse

this is a birdhouse that will need some assembly before putting it on the tree. here are the following items you will need:

1. string
2. both 3-D printed parts
3. a thin stick to help push the string through the small hole

step 1. take the string and cut off a short piece. then pull it through one of the holes on either part ( if you are doing this on part 1 don't do it on the top string.) you can also use the stick to help push the string through.

step 2. get the other part and put both of the parts on top of each other.

step 3. take the string and pull it through the hole on the other part and tie the string together to connect the parts together.

step 4. repeat step 3 until all the holes are connected together. (except the hole in part 1 on top.)

step 5. get another piece of string and pull it through the hole in the top and tie it together.

step 6. you can now put some seeds in it and put it up the tree.