NANO Temperature Tower Mk.52

A powerful nano-sized no-nonsense temp tower to help you fine-tune a profile for your filament. Inspect stringing artifacts from 230C (at the lowest layer) to 190C (at the highest layer).

* Uses only 150mm of filament - why waste perfectly good product?
* Takes under 6 minutes to complete - because time is money!
* 100% free under a liberal CC license - so you can remake it and share it however you want.

If you don't want to set up the tower yourself, I have included a fully configured Mk3S+ G-Code

Instructions; 

Initial hot-end temp 220C
Layers and perimeters;
-perimeters; 1
-solid layers top; 1
-solid layers bottom; 1
-min shell thickness top; 0.2
-min shell thickness bottom 0.4
Infill; 0%
Supports; none
Add a height modification layer 24mm-25mm; Top solid layers;zero

Add custom g-code inserts as follows