Oral-B Pro 1000 Charger Pad Saver-Spacer

I don't know about you, but my Oral-B Pro 1000 charger gets nasty and nasty fast!  It's a pain to clean once it's gotten to that point.  

I've created a thin plastic film to put in the middle to help make this process ultra fast!  

• Cost about a penny or two to make!
• Less then 4 minutes to print!  
• Has a pull tab for easy removal!
• Tiny spacer to let a little bit of air flow in under the brush if you want (2 versions). 

Suggested printing setup:

• Suggest using PETG or ABS for it's water resistance over PLA.
• Smooth Side Down printing.
• Suggest setting Bottom Surface Pattern as Concentric to help better seal water away.
• Let it cool down before taking it off the build plate.  Very thin print (1mm-2mm).

It's a little tight when you put it on, but that's by design.  Adds a better seal to the part that sticks up.  Plastic is thin so it might be a little tight, but it'll go one pretty easy.

Enjoy!