Eufy Spaceview Monitor Belt Clip

The Eufy Spaceview is great but it's not easy to cary it around the house while your baby is sleeping. If you put it in your pocket, it's easy to click buttons or muffle the speaker. To solve this problem, I designed a part that you can snap the Eufy Spaceview into that allows you to hang the monitor on your belt or pants. 

The part prints in two pieces to make it printable without supports as well as optimizes layer direction. To assemble the two parts, you'll either need super glue or an 8mm countersunk M3 bolt + nut. 

The clip works well. It's easy to snap the monitor in and out of the clip and it fits a pretty wide variety of pants and belts (though it can be loose with some so I wouldn't do any cartwheels or anything when wearing it). I designed it so that the clip does not block any buttons, ports, speaker, or microphone. The kickstand and antenna are blocked but can be easily deployed by removing the clip, then re-attaching the clip once deployed.

I designed this using OnShape, you can view the model here.