Toiletpaper rolls Holder

you need 3 parts to assembly this: the hook, the roll shelves and a rope (12mm wide rope)

just print as much shelves you need and slide the rope through them, you can block each part by a generous amount of electric tape or duct tape (also for the hook) or make a knot at each shelf

how to put the rolls? just bend the rope along the shelf and slide them through the center of the roll, slide the roll until it reaches the top of the desired shelf and that is, the shelf will support the roll when put horizzontally after the slide

really minimal,  not really practical but it does the job and need really small amount of plastic and time to print (also minimun space occupied when assembled)

i printed that in classic pla, probably better in tpu but it bends well with the rope and slides without much effort

tell me if you liked it!

ps: also provided a traditional shelf to simply put rolls on, also a second tipe of hooks to put in place