7-Piece Towel Holder

This model has five parts which easily fit into each other during assembly. Once all parts are connected, the towel holder can be screwed onto the surface of a wall.

Step 1:

Join both Torus pieces (TowelTorus LEFT & RIGHT) together to create the full towel hook. I highly recommend to glue these pieces together, so they don't slide away from each other over time.

Step 2:

Get the Wallpiece and Connector2 parts along with the TowelTorus from Step 1. Align the TowelTorus hole parallel with the ones in Wallpiece. If done correctly, Connector2 should slide smoothly in between these parts. After sliding Connector2 into the holes, slide in Connector1 on its opposite end.

Step 3:

Screw the towel holder onto any wall you'd like to put it on. This design uses # 10 x ¾ inch sheet metal screws.