UniFi6 Long-Range Beam Clamp Mount

Designed this Mount to be used with most common beam clamps. I needed a way to mount several of these in our Warehouse on the steel beams.

This mount will adapt to most beam clamps. For reference I used these as my clamps - https://a.co/d/1Ntk4En

I then used M4x12 (Qty 4) screws to mount the Plate that came with the UniFi6 Long-Range access point.

For the Beam clamp I used M5x16 but you can get away with M6 I believe as well. Just depends on what beam clamp you are using. The hole is sized at 6.25mm wide.

Print Settings

Printer:

Kywoo Tycoon Slim

Rafts:

No

Supports:

Yes

Resolution:

.20

Infill:

20%

Filament:

Any

Notes:

I just used supports on the main center hole that is touching the bed plate.