Filament roller guide & runout sensor mount for Ender 3 v2 Neo

Patreon - https://patreon.com/CosmicNimbusPrinting
Cults3D - https://cults3d.com/en/users/CosmicNimbus

Hi there Ender 3 v2 / Neo user !

I have combined some parts from a few models and built a slightly over-engineered filament guide & runout sensor mount. 

I've printed this all at 0.2 in PETG and 20% infill. Instead of buying 608 bearings, I chose to print this simple bearing that I have linked and attached the high tolerance version (which I have had the most luck with). I found the bearing would run a little smoother by adding a little bit of grease to it, and they have been spinning nicely for almost a year now.

To build this bad-boy you will need to print

• 1x Main body
• 2x Bearing inserts
• 4x Pulley halves
• Fast 608 bearing (or a bought one should fit too)

There are a couple of mistakes in the model, but Cura doesn't seem to mind fixing this for me 😁

Happy printing !

This is a combination of these 3 models into a filament guide with swivel arms and mount for the filament runout sensor