Dewalt Battery Charger Mounts

DCB112, DCB115, and DCB118 Chargers.
78
478
1
3358
updated December 18, 2023

Description

PDF

So i wanted to make various ways to mount Dewalt Battery Chargers (DCB112/DCB115 and the DCB118)

The DCB112 and DCB115 screws are 114.3mm apart, and the DCB118 is 133.4mm

First option, is a simple 2mm thick alignment jig.  you can print this out and quickly identify/mark your surface for perfect screw placement.

If you are mounting on a single stud,  you can use Center Stud Mount versions.   These need a single screw and have the pegs to slide your battery charger over already built in.

Pegboard accessories are usually a pain to print,  so if you want to mount on a pegboard,  simply print the center stud mount along with the pegboard model.   I made it this way so the center stud mount slides in from behind the pegboard model and you can glue it if you want but it holds in place just fine.    This way you can print both of these directly on the build plate without any supports (see picture how i printed them).    This pegboard setup is ultimately what i chose to go with for my chargers.     

I also made a version to use on a slatwall.  I did not print this, but i know it works as ive designed quite a few other slatwall models in the past.

 

Hope this is what someone is looking for, please share a make.

Tags



Model origin

The author marked this model as their own original creation.

License