Castle Tower – Easy Support Free 3D Print for RPGs and Dioramas
28mm castle tower – support-free print for RPGs, wargames, or expanding your tabletop stronghold!
378
1400
8
7663
updated
September 9, 2025
Makes
Comments
I didn't like my wireless antenna for my motherboard so I printed this and hid the antenna inside.
That's come out really nice at that scale 😁
@Khrys3D_511249 Thanks for sharing 😁
Printed some extra pieces to get a little more height. Had some problems but for my first time as a resin pint, it's not terrible.
@ironsights_1913381 That's your first resin print? I wish mine had been that good. Well done and keep going 😁
Green tower printed at 50%. Extended floors to make fully flat bottomed layers so printed clean without supports.
@ABitMoreAdve_1679699 Looking good 😁
This is super nice and is on my list of things to print next! Would love to see the rest of the castle!
this looks really cool! gonna save it for later
Great detail. Nice job of printing 😁👍👍👍
I love this print. super easy to print even on FDM printers. Printed at .12 layer height on Bambu Labs X1C. Support on the bottom to support the floor but otherwise no other support needed. Printed in Sunlu Grey PLA. approximate time is 22 hours for all pieces.
@Morgan3d_117594 Wow buddy, excellent print!