DRAPED ELEGANCE | Table Lamp
Enhance your space with our captivating table lamp shade that mirrors the natural charm of a draped fabric. This shade bathes your surroundings in gentle, warm light, creating an inviting atmosphere that effortlessly combines elegance with an organic touch.
It rests on a sleek tripod, designed for either E14 or E26 & E27 bulb sockets.
You can get the power cords from Amazon here:
For Europe:
E27 cord: https://amzn.to/3OVrZjK
E14 cord: https://amzn.to/3TchBqs
For the US:
E26/E27 cord: https://amzn.to/3V5VYJB
This lamp shade was designed to be printed fast, in a couple of hours in vase mode.
There are 2 versions of the lamp:
- the original one
- and a smaller version that can fit on PRUSA printers with 210 x 120 x 220mm printing volume.
Also, each shade comes in 2 versions:
- a smooth surface version (the original)
- and a textured version with little bumps all over to make it look more like paper/fabric, which helps hiding little printing defects.
SHADE (Large) | Ø 230 x H 225 mm | Printing: 2h ~ 3h (vase mode)
SHADE (For Prusa) | Ø 208 x H 218 mm | Printing: 2h ~ 3h (vase mode)
E14 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h
E14 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h
E26/E27 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h
E26/E27 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h
3D PRINTING SETTINGS
SHADE:
The shade must be printed with bottom and top faces "open".
You can either use the "spiralize" function to print in "vase mode" with 1 wall perimeter only (fine for the smooth shade version).
If you want 2 lines in your walls (recommended for the textured shade), do not activate "spiralize", but instead use the following settings:
Resolution: 0.2 to 0.3mm / layer or less
Wall Line Count: 2
Infill: None
Top layers: 0 (to get rid of the top face)
Bottom layers: 0 (to get rid of the bottom face)
Build adhesion type: 6 to 8mm brim
Supports: None
BASE:
The base must be printed upside-down, so with the feet pointing up, and the round opening for the E14 socket on the printing bed.
Resolution: 0.2 to 0.3mm / layer or less
Wall Line Count: 2
Infill: 15 to 20% gyroid
Build adhesion type: 6 to 8mm brim
Supports: None
The author marked this model as their own original creation.