BITTY FUNKO POP Display For Shelf NO SCREWS

This model gives you a place to put your bitty FUNKO pops and slides right onto almost any shelf. I made a model to hold 1 bitty pop and one model that lets you put 4 bitty pops with the display case (shown in the photo). If it is too big you can put foam pads on it to make it stay in place

If you have any other size recommendations like three pops or two pops, please let me know.

UPDATE: I made the back plate longer so the pops would be flush with the shelf.

UPDATE 1.2: I flipped the model over, so you don't have to in the slicer.

UPDATE 1.3: added a TEST version for 16mm shelfs and a full version for 16mm shelfs

Print Settings

Nozzle:

0.4mm

Filament:

PLA

Infill:

20%

Quality:

0.2 Fine Strength

Supports:

NONE