Logitech C270 Improved Wide angle Lens Mount

I updated CO-OCD's great design for the Logitech C270 by adding threads and air vents. After I started printing polycarbonate in my enclosure at around 38C ambient my entire C270 setup started warping. See the last 2 photos for the warping of my original parts.
This could be due to two reasons:

1. I used HTPLA which the ambient + camera might overheat so I reprinted in PETG

2. The camera generates a lot of internal heat so I added air vents to the case Additionally with the weight of the wide angle lens I could no longer trust the push fit design, so I added threads to both ends of the wide angle lens mount. This is much more secure.

   You will need to get a focus ring from another design upload. I use this one: https://www.thingiverse.com/thing:3088614