IKEA PAX holder for Skadis board

This IKEA Skadis mount fits into a IKEA PAX wardrobe.
I wanted a screwless model. In order to cope with the weight, I used 3 holes per base. (I did not do any load test).

I used the following settings for printing on my 0.4mm nozzle

• Extrusion width : 0.6mm (I assume 0.4mm works fine, too)
• Layer hight : 0.28mm (I assume 0.2mm works fine, too)
• Walls : 5
• Top+Bottom : 3
• Infill : Gyroid 15%
• Enable support (build plate only) 
• Filament : PLA+

Assembly:

1. Push the hooks into the (top outer) slots on the Skadis board, “in and up” (it's a tight fit)
2. Slide the bases (marked L and R) onto the hook's dovetail
3. Push the base parts into the PAX holes (I started with the one further inside)
4. Adjust the Skadis board horizontally by sliding left/right in the dovetail