Zero Y-Offset + 5015 Fan Backplate for Sprite Pro

~ UPDATE: 08/08/2024 ~ Added a v3, easier nut catch more sturdy side mounting options. V3 has three options. Top mounted, Double mounted and bottom mounted. If you're going to use the Top mounted or Double mounted options, you will need to use a special bolt an Ultra Thin Super Low Flat Head bolt which can be found at either one of these links:

     -Ultra Thin Super Low Flat Head Bolt

          -Ali Express Link ← For this link make sure to select the M3x4 option!!

          -Amazon Link

I designed an entire cooling system for the sprite extruder which can be found here(this is how I got the cool video below of the supports being printed): https://www.printables.com/model/558083-the-heartbreaker-5015-dual-fan-duct-system-for-s1s

With this system you need to have a Zero Y-Offset for your BL touch for everything to fit together properly. In that cooling system, it uses Dual 5015 Blower Fans. I thought it would be cool to have a blower fan as the heater block cooling fan because of how much more air it outputs. When upgrading to a high flow kit, I was having issues with heat creep on the stock cooling system. This completely ELIMINATES heat creep. 

Parts: 

     -For this model there are two options, one for heated inserts and one without. If you have the heated inserts, that is a major plus if you do have them, you will need two M3 heated inserts. Here are the heated insert tools I am using: https://www.amazon.com/gp/product/B08K1BVGN9/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1 and https://www.amazon.com/gp/product/B08B17VQLD/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

     -You will need one 25mm or 30mm M3 screw as well as one M3 bolt. Here is the screw set I am using: https://www.amazon.com/gp/product/B0B6H9H8S5/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

     -One 24V 5015 Blower Fan which can be found here: https://www.amazon.com/gp/product/B07DB7DLMM/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Printing:

     -NO SUPPORTS ARE NECESSARY! I've designed this model in a way that you do not need supports. The only portion that would “need supports” I've handled with design. 

     -Print this at .2 layer height with at least 3 walls. 

Post processing:

       -The only post processing needed is to insert the heated inserts if you're printing that model. 

Everything should print in about an hour. 

***update 12/24/23: added an inset near the fan outlet to better fit my heartbreaker model better***
 

Need help calibrating your printer? Try out my calibration cube by clicking this link → https://www.printables.com/model/650696-deathly-hallowsharry-potter-calibration-cube