1913 Bugatti Type 22 Torpedo
https://youtu.be/PVl3cEkSSo0?si=QV8NKKV6G-LAw_vm
https://youtu.be/orNbJ3KgBIU?si=_lESjRb1NG5c3Ji0
Fewer than 5 made.
Designed from screenshots from YouTube videos in blender
Printing instructions
Pieces fit on Ender 3 Pro bed.
Print hood nose down or nose up. Printing in original position may cause a break when printing (it's thin at the top)
Print rear axle in vertical position with support.
Overall use normal support, but where parts fit together, if support is hard to remove out of holes, exclude support from the hole.
Played with print orientation for radiator and seat (small details) until the details printed best.
Overture PLA at 205, bed 60
Frame is most difficult of the pieces to print as small parts can break when removing supports - be careful.
That said overall print was just a couple of days for two full sets.
The author marked this model as their own original creation.